Important Info About New M27 and M47

[Blinder-Guy]

IT IS VERY IMPORTANT TO READ INSTRUCTION CAREFULLY BEFORE INSTALLING!!!. The new heads do not come with software in them. The software is in the CPU and the very first time it is powered on you have to place it in the jam mode or #2 for 1 minute so the heads can be programed. If this is not done the heads will not work properly. So when installing make sure the switch stays off until fully installed and ready to program. If you do not follow these steps you will have to update software from website again to CPU and start over......I found this out the hard way today after going to test a car for a Blinder customer whose unit was not programed properly.

The reason for this is the software is no longer stored in heads. This way once CPUs are available people who bout the J17 version Blinder earklier can purchase a CPU and switch and when they plug the old J17 heads in the CPU will update them to the new units

['09 Milan]

Glad you told us this as I usually update on the bench before I install...

So if anyone ever disconnects their car battery after an install - REMEMBER to run the program again!

[Blinder-Guy]

We tested member "Tom's" car today....He has a black 2009 Infinity G37.
We used the Prolaser3 and Truspeed...We did 3 shots each gun. HL, CM, PH and all were JTG....He took some video...None was through the hud so you will just have to believe him and I. He did some of the shooting himself to verify for his own eyes..I told him sometimes where to aim and sometimes I told him to shoot what ever he wanted.

I take that back I did get one PT at 17ft when he about ran me over. That was with the Truspeed.

Lots of chrome on this car in the grill area and the headlights are wrap around so hard to protect...All in all a good day.

I am sure he will chime in later.