9500I USB update available!!!

[CJR238]

Updates via USB are now available from Escort for the 9500I!
It's been a long wait but here it is!

Go to Escorts sight, register than download:
https://secure.escortradar.com/9500iregister.asp

First update 9/1/08 for the 9500I consisted of:

1. Improved Laser lock out logic.

2. Increased speed pilot limit to 255 mph

3. Improved meter ramping

4. Improved calibration of voltage circuit

5. Fixed power on/off when turned off by the power button

6. Added mark location capability during an alert

7. Changed ZR3 to SHFT when a shifter is attached.

[CJR238]

FYI, you will need a USB cable and a power source to power up the 9500I.

[TSi+WRX]

Also, be sure to perform a hard-reset after you've updated the unit.

Some have reported rather strange behavior of their 9500i, after the reflash - which was effectively "cured" via a hard-reset.

It is now recommended that after any such updates, a reset be performed.

[CJR238]

Originally Posted by TSi+WRX

Also, be sure to perform a hard-reset after you've updated the unit.

Some have reported rather strange behavior of their 9500i, after the reflash - which was effectively "cured" via a hard-reset.

It is now recommended that after any such updates, a reset be performed.

Good point! That's kind of a pain setting everything back to your 9500 preferences though... I set allot of things.

[TSi+WRX]

^ +1.

I change a lot of the defaults as well. Indeed, it's a pain in the butt!

[nyc1dxo]

"Also, be sure to perform a hard-reset after you've updated the unit"

Is there a procedure for this?

[TSi+WRX]

^ Hold down the "SEN" and "BRT" buttons, while turning on the unit via the main power button.

You should see/hear something akin to "RESET."

Again, be sure to go through and re-do your preferences through the menus. The reset will, as it suggests, reset all preferences to factory default.